581. In case the vessel speed is low : In case vessel speed/Direction fluctuate, increase the valuemore.2. In case the vessel speed is high : Set up the smoothing low and vessel speed/Directionchanges fast.Vessel speed Pos.[position]Spd.[vesselspeed]Crs.[Direction][speedmode]2~5knots 0 080~130 70~90 Low speed5~10knots 0 020~100 20~70 Low speed10~15knots 0 010~030 10~20 Mid. speedAbove 15knots 0 000~001 00~01 High spee[note] ☞☞☞☞ Position smoothing value can be zero.The above table is basic value based on vessel speed and , according to navigation condition,adjust the value so that the change of speed and direction is optimum condition.3. [5.Speed Mode] set upPress the button as below and the speed will change to [High speed],[Mid. speed],[Lowspeed] ,then choose the speed.( ) ( ) ( ) ( ) ( ) ( )4. [4.Smoothing set]Press the button as below.( )( ) ( ) ( ) ( ) ( ) ( ) [5.Speed Mode] Entervessel speed using [Number button] ( ) Direction value mode Enter direction valueusing [Number button] ( ),The Range☞☞☞☞ : Position (0~9), Speed(000~399), Direction(0~99)2.4 Cursor SetupThis enables the operator to set up the information on Cursor shown on the plotter display.( ) [2.SET] ( ) [4.CURSOR SET] ( )
