Sandrigarden GET 700 Operator's Manual
                                                    | |
ENGLISH7SPECIFICATIONSTROUBLESHOOTINGPROBLEM• Motor will not start• Cutting head will not turnwhen throttle is squeezed• Cutting head will not advancelineCAUSE1. Motor stops / will not start2. Cutting head bound withgrass or debris1. Flex shaft broken2. Flex shaft not engaged1. Cutting head out of line2. Inner reel bound up3. Cutting head dirty4. Indexing teeth worn orburred5. Line welded6. Line twisted when refilled7. Nut enough line is exposedACTION1. Check curd to see if it isplugged into an electricaloutlet2. Stop motor and clean cuttinghead1. Contact service dealer2. Contact service dealer1. Refill with new cutting line2. Replace inner reel3. Clean inner reel and outerspool4. Replace inner reel and outerspool5. Disassemble, remove thewelded section and rewindthe line6. Disassemble and rewind reel7. Push the Bump Knob andpull out 140 mm of line untilthe line is outside of thecutting headAll information, illustrations and specifications in this manual are based on the latestproduct information available at the time of printing, We reserve the right to make changesat any time without notice.MODELMotorMotorOperating RPMIgnition SwitchDrive shaftCutting headVibration LevelSound pressure level(no load)Measured sound powerlevel (no load)Guaranteed sound power level(no load)Cutting path diameterOperating weightTrimming line diameterGET 700Electric7000-8000 g/mControl switch6,2 mm"Bump Head"reel feeding1,65 m/s2 (700 W)LPAm = 74,6 dB (A) (700 W)LWA = 94,6 dB (A) (700 W)LWA = 96 dB (A) (700 W)370 mm (700 W)4,9 Kg (700 W)1,6 mm (700 W)GET 1000Electric7500 - 8500 g/mControl switch6,2 mm"Bump Head"reel feeding2,15 m/s2 (1000 W)LPAm = 75,75 dB (A) (1000 W)LWA = 95,36 dB (A) (1000 W)LWA = 96 dB (A) (1000 W)370 mm (1000 W)5,5 Kg (1000 W)2,0 mm (1000 W) |
manualsdatabase
Your AI-powered manual search engine