Sansui HDLCD5050 Owner's Manual

Sansui HDLCD5050 Owner's Manual Manual pdf 6 page image

EN 6How to attach the standLCD PANEL SIDENOTE:• Unplug the AC cord from the AC INPUT terminal.• Before beginning this process, assure that the TV is laid on a clean, safe, and cushioned surface to avoid anydamage to the unit.• Do not touch or press the TV-screen, glass might break under pressure.Place the TV on its front onto a table.Align the stand’s bottom-plate (supplied) as seen here.It will fit in only one direction.Hold the unit and attach the stand frame (a) slowly and secure the stand frame (a) with the 4 screws (supplied),4x35mm (5/32 x 1-23/64 inches) as shown in figure 1.Finally secure the bottom-plate (b) with 5 screws (supplied), 4x12mm (5/32 x 15/32 inches) as indicated by thearrows in figure 2.Be sure to follow the instructions. Insufficient tightening or incorrect installation of the stand will not supportyour unit correctly, and could result in damage or injury from tip-over.•How to remove the standWhen you transport this product, remove the stand and pack flat against the back of the unit in the carton. Toremove the stand, perform these steps in reverse order.For wall mounting, the base must be removed. To disconnect the base/stand remove the 4 screws from the back(see page 5).Figure 1Figure 2(a)(b)(b)