Sansui SLED4680 Owner's Manual

Sansui SLED4680 Owner's Manual Manual pdf 18 page image

18Memorizing channelsThis TV is equipped with a channel memoryfeature which allows channels to skip up or downto the next channel set into memory, skippingover unwanted channels. Before selectingchannels, they must be programmed into theTV’s memory. To use this TV with an antenna, setthe Signal Type option to the Air mode. Whenshipped from the factory, this menu option is inthe Cable mode.Air/Cable selection1 Select “Channel”, then press ▶ or ENTER.2 Press ▲ or ▼ to select “Auto Ch Memory”, thenpress ▶ or ENTER.3 Press ▲ or ▼ to select “Signal Type”.4 Press ◀ or ▶ to select “Air” or “Cable”.Air - VHF/UHF channelsCable - CABLE TV channelsAutomatic Search StartAuto Ch MemorySignal Type Cable: Adjust: SelectCABLE CHARTThe chart below is typical of many cable systemchannel allocations.NOTE:It may take a few seconds for a digital channelpicture to appear on screen after being selected.Automatic Search1 Select “Channel”, then press ▶ or ENTER.2 Press ▲ or ▼ to select “Auto Ch Memory”, thenpress ▶ or ENTER.3 Press ▲ or ▼ to select “Automatic Search”, thenpress ▶ or ENTER.Auto Ch MemorySignal Type CableDigital Channel Found : 5Analog Channel Found : 7Programming Now: Select ENTER:CancelAutomatic Search Stop•4 The TV will begin memorizing all the channelsavailable in your area.It may take from 15 minutes to 30 minutes tocomplete memorizing digital cable channels.Depending on the reception condition, a bardisplay may not advance for several minutes,please be patient.•NOTE:Memorizing channels is best accomplished duringevening “PRIMETIME” hours, as more stations arebroadcasting digital signals. Memorizing channels canonly be accomplished while a station is broadcastinga digital signal to set that channel into memory.If you are unsure of the digital channels availablein your area, you may visit www.antennaweb.org toreceive a list based on your address or zip code.Should you require further assistance you may callour toll-free customer service line at 1-800-289-0980.New digital channels may be added to your areaperiodically, it is recommended to perform the“Automatic Search” procedure regularly.Adding ChannelIf you find a new digital channel unregistered, you canadd the new channel into the channel memory.1 Tune in the new channel.2 Select “Channel”, then press ▶ or ENTER.3 Press ▲ or ▼ to select “Add/Delete”, then press ▶or ENTER.Add/Delete >>Clear All >>Add/DeleteAdding Channel >>: Select ENTER:Set4 Press ▲ or ▼ to select “Adding Channel”, thenpress ▶ or ENTER. The new channel will beadded into the channel memory.Add/Delete channelYou can select the channel that you want to skip.1 Select “Channel”, then press ▶ or ENTER.2 Press ▲ or ▼ to select “Add/Delete”, then press▶ or ENTER.3 Press ▲ or ▼ to select “Add/Delete”, then press▶ or ENTER.4 Press ▲ or ▼ to select the channel that you wantto skip.CH Signal2 Analog3 Analog Add3-1 Digital Delete3-2 Digital Add4 Analog DeleteAdd/Delete: AdjustAdd: Select5 Press ◀ or ▶ to select “Add” or “Delete”,whichever function you want to perform.6 Repeat steps 4 - 5 for other channels you want toadd or delete.•••