Sanyo 1 682 351 01 Service Manual
                                      |
Safety Precautions:1. Be sure to ask an authorized service personnel to carry out setup.2. Thoroughly read this instruction before setup and follow the steps below precisely.3.The wall to be mounted should be made from solid materials. Only use accessories supplied by the manufacturer.4.Very carefully handle the unit during setup. We are not liable for any damage or injury caused by mishandling or improper installation.5.Be sure to place the unit on a stable and soft platform which is strong enough to support the unit.6.Do not uplift the speaker when moving the display. The appearance of the unit may different from the actual ones.7.Design and specifications are subject to change without notice.8. Retain these instructions for future reference.WALL MOUNTING INSTRUCTIONSWall2. Due to the wall mounting fix-groove leaning to theright side, the whole unit will lean to right side afterinstallation, please carefully measure the position ofthe holes you want to drill, refer to the parameterson Fig.2 when drilling the holes.Note: The "X" in Fig.2 represents a data. It may be200mm or 400mm or 600mm.Fig.1 Fig.2Fig.54. Use the 4pcs combination screws to fixthe wall mounting connector to the rearof the display unit.(Caution:the directionof the connectors should be strictlyconfirm to the diagram illustrated above).5. Put the back of the display unit close to the wallmounting holder, insert the four wall mountingconnectors into the four calabash-shaped holes onthe wall mounting holder. (Fig.5)Take out theseparts from theboxWall Mounting HolderExpansion BoltWood ScrewCombination ScrewWall Mounting ConnectorFig.3aFig.4Fig.6Fig.73a. Screw 4pcs expansion bolts to fix thewall mounting holder on the wall.6. Let the display unit slowly slide down tothe end of the calabash-shaped hole.(Fig.6)7. Push rightwards carefully until the wallmounting connectors fully slide into theright fix-grooves and be sure the mountingis secure.8. If you want to dismount the unit do the above steps in reverse order.(Unit:mm)Rear wall mounting hole centerWall mounting fix-hole center200 27X81. There are three options of wall mountingholder with different specifications:200200,200400,200600. Please check yourwall mounting holder for its specification.WallFig.3b3b. If your wall is a wooden structure, pleasefix the wall mounting holder on the wallwith 16pcs wood screws.Note: All the wall mounting parts areoptional and may be unavailable inyour model.Below we will show you how to mount theDisplay on the wall using our company’swall mounting components. |
Related manuals for Sanyo 1 682 351 01
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine