Sanyo AVP-429 Instruction Manual

Contents

Sanyo AVP-429 Instruction Manual Manual pdf 23 page image

Getting StartedRunning Initial SetupPerform the following steps before you press POWER on the remote control to turn on your TV set.1. Insert the batteries into the remote control unit.2. Connect the antenna cable to the TV.3. Plug in the AC power cord to the AC outlet.After you finish connecting the TV, you can run the Initial Setup to create a list of available analog and digitalchannels. The Initial Setup screen appears when you turn on the TV for the first time after purchase. We stronglyrecommend you to perform initial setup according to the steps below. Welcome!Use the Up and Downarrows on your RemoteControl and Select thelanguage you want to usefor menus and messagescreens.Press OK to continue in EnglishEnglishFrançaisEspañolTime ZoneUse the Up andDown arrows andpress Select on yourTime Zone.Press OK to continueGO BACKAlaska (US)Hawaii(US)Pacific (US, CAN)Mountain (US, CAN)Central (US, CAN)Eastern (US, CAN)Scanning ChannelsChannels FoundDigital: 3Analog:3Scanning may take a few minutes - Please be patientStop ScanSignal2.02.12.23.04.04.1Daylight SavingDo you observe DaylightSaving?Press OK to continueYesNoGO BACKRF Input SourceSelect the source for yourtelevision signal.Press OK to continueAntennaCableGO BACK(Example)22Setting LanguagePress ?/? to select the desired language listed on the screen, and thenpress OK to confirm and continue.Press ?/? to select a proper time zone according to your area, and thenpress OK to confirm and continue.If you want to return to previous screen, please highlight [GO BACK] itemand press OK to return.Press ?/? to highlight [Yes] item if you want to observe daylight saving, oryou may select [No] to abandon daylight saving and then press OK toconfirm and continue.If you want to return to previous screen, please highlight [GO BACK] itemand press OK to return.Press ?/? to select [Antenna] or [Cable] according to what kind of connectionis made with your TV, and then press OK to confirm and continue. If youchoose [Antenna], the TV starts Auto Program automatically.If you choose [Cable], there are 3 kinds of CATV system, including STD,HRC and IRC. Select the one matches to your TV. Select [Automatic] whenyou do not know which one to select. When you select [Automatic], the unitautomatically detects the type of your cable system. If the unit fails to detectthe type of your cable system, please consult with your cable TV companyabout the type of your cable system, and then choose the correct type beforeAuto Program.If you want to return to previous screen, please highlight [GO BACK] itemand press OK to return.Once you have finished selecting RF input source, the unit starts autoprogram.Auto Program may take a while to complete. A progress bar is displayedwhile available channels are being scanned. If you select [Stop Scan] tocancel the Auto Program before all receivable channels are scanned, youneed to run Auto Program at a later time.Auto Program will create a list of receivable channels for the current input .You will be required to run Auto Program for RF input to create a list ofavailable channels.Setting Time ZoneSetting Daylight SavingSelecting RF Input SourceStart Auto Channel Program...