Sanyo CDF-R800 Operating Instructions Manual

Also see for CDF-R800: Service manual Operating instructions

Contents

Sanyo CDF-R800 Operating Instructions Manual Manual pdf 9 page image

Audio ControlL o u d n e s s b u t t o n---Audio control button0 VOL (Volume) controlPress the ( F\ ) side of the Audio control button to increase, or the ( b ) side todecrease the volume level. During adjustment, [VOL] appears on the display.l BAS (Bass) I TRE (Treble) / BAL (Balance) / FAD (Fader) control0 Pressing the Audio control mode select button (@), select the desired mode.W i t h e a c h p r e s s the mode shifts to the next setting. See below.@ Pressing the ( F\) or (u) side of the Audio control button, adjust the level.f-N o t e :l Adjust the Bass, Treble, Balance or Fader within 5 seconds after selectingthe Audio control mode (the selected mode indicator appears on the display).If no mode indicator appears on the display, pressing the ( (ii\ ) or ( u)side of the Audio control button will adjust the volume.H i n t :l Press and hold the audio control button to change the level quickly.Mode shift Press b. Press F\ . Display1BAS (Bass) To decrease To increase -7 - 7T $ E (Treble) To decrease To increase -7 - 7d A L (Balance) To the left speakerF!& (Fader)To the right speakers o - 9+L (Volume)To the rear speaker To the front speakers o - 9To decrease To increase o - 1 9N o t e :l With each press, the level changes. But the Audio level shown on the displaydoes not change with every press. Use it to know the rough level.l Loudness (LOUD)Press the Loudness button ( g) to emphasize the Bass and Treble range at lowlistening level. [LOUD] appears on the display. To cancel the mode, press the but-t o n a g a i n .8