Sanyo CE42LM4R -E Instruction Manual

Contents

4■ Connect the display unit to Aerial, VGA, BNC and Scartconnector as required.1. Connect the in-line power connector to the connector attached tothe display unit as shown above.2. Connect the power cord of the display unit to a wall outlet.✐ As this product does not have a mains On/Off switch, pleaseensure your mains plug is easily accessible.✐ The display unit is prepared for a mains voltage AC220~240V,50Hz. To completely switch off the mains, or when the display unitis not to be used for an extended period of time, it is advisable todisconnect the power cord from the power outlet or disconnect themains coupler..✐ Please use the correct mains lead supplied with the set for yourarea3. Warning: To prevent injury, the unit must be securely attached tothe wall in accordance with the installation instructions.1.■ HDMI (High Definition Multimedia Interface)This TV set has an HDMI connector. When connected to the HDMIsource and HDMI is selected using the remote control,There is a shorttime period before the picture appears at a much higher resolution.This connection is located at the back of the TV set next to the aerialsocket.2. Y,Pb,Pr connection (AV2)This LCD monitor has a choice of Y, Pb, Pr or RGB , H/V connectionsYou can connect your DVD player to the Y, Pb, Pr terminals insteadof using a scart lead. This can support high definition in analoguecomponent form. RGB, H/V can be used as a PC input via the BNCterminal.3. PC connectionThis LCD monitor has a PC connector.Youcan connect a PC to the LCD monitor and use it as a monitor display(see page 9).To switch between TV, AV1, RGB, AV2 RGB H/V or Y, Pb, Pr, AV3,HDMI or PC mode press the TV/ AV switch on your remote controlrepeatedly or press and hold the TV/AV button for a few seconds andselection menu will appear on screen use the e or d buttons to selectthe correct mode.4. RS232C IN/OUT: Is a input for external commands to control themonitor (see page 9)Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on thebatteries match the "+" and "-" marks inside the unit into the remotecontrol handset.INSTINSTALLAALLATIONTIONStep : 1 Connections (Essential)AC Mains OutletWARNING! High voltages are used in the operation ofthis set. Refer service to qualified service personnel.Security fixing pointInline connectorHDMICoaxial aerial INAudio monitorOut AV2 audioINSerial portsIN/ OutServicesAV3 IN/OutBNCAV2 IN/ OutBNCWallmountfixingpositionsSerialPort-INSerialPort-OUTServiceStep : 2 Remote control battery installationGB GB