2 Connect Signal to the DTV’s IntegratedAnalog / Digital 75 ohm Antenna Inputterminal.5Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032GETTING STARTED(REQUIRED INITIAL SETUP)1 Install batteries in remote control (2AAA,not included). 3 Plug in AC power cord(120V AC, 60 Hz).5 Perform “All Channel Search.” The AllChannel Search will search for off-air digitaland analog channels, and analog cable chan-nels. The DTV can receive cable or off-airchannels, but not at the same time. If aftertwo searchesthe DTV stillfails to detectany channels,the DTV willtune to Video1.PRECAUTIONSTo ensure safe operation, please observethe following precautions:Replace both batteries at the same time. Donot use a new battery with a used battery.Risk of explosion, if battery is replaced byan incorrect type.Do not expose the Remote Control Unit tomoisture or heat.RF ANTENNACABLE ORCABLE BOX OR SATELLITE BOXORDTV ANALOG/DIGITALANTENNA INMatch the “+” and “–” signs onthe batteries with “+” and “–”marks inside the remote control.To 120 V AC outlet.INITIAL ON-SCREENALL CHANNEL SEARCH4 Press the POWER key. (Follow on-screeninstructions.)Note: IfEXIT is pressed,the DTV will skip ChannelSearch and tune to Video1without storing any chan-nels in the Channel Mapdatabase.THE TUNER IN THIS DTV CAN RECEIVE:1. Digital and / or Analog Off-Air Signals from an RFantenna.OR2. Analog or ClearQAM cable channels.Note: You must search for ClearQAM channels usingthe “Digital Cable Search” menu option.OR3. The output from a VCR or cable box.Digital signals can also be received through theHDMI jacks.Digital signals from a Set-top (STB) Box should bereceived through the Video 1, 2, or 3, or HDMI Input1,2, or 3 jacks.This DTV can receive ANY unscrambled RF signalbeing broadcast.ANALOG CHANNELS DIGITAL CHANNELS