Sanyo DP39E23 Owner's Manual
  | |
The American Academy of Pediatrics dis-courages media use by children youngerthan two years. For more information,visit www.aap.org.Please read before operating your HDTV!PROTECTING THE LCDSCREENCAUTION: The screen can be damaged ifit is not maintained properly.• Do not use hard objects such as hardcloth or paper to clean the screen.• Do not use excessive pressure whencleaning the screen; excessive pressurecan cause permanent discoloration ordark spots.• NEVER spray liquids on the screen.HANDLING PRECAUTIONS• Handle by the cabinet only.• Handling by two or more people is rec-ommended.• Never touch the screen when handling.• Handling damage is not covered underwarranty.• Do not remove the protective filmcovering the front cabinet whilehandling the HDTV.POSITIONING THE HDTV• Always use a firm and flat surface whenpositioning your HDTV.• Do not position the unit in a confinedarea.• Allow adequate space for proper venti-lation.• Do not position the HDTV where it iseasily reachable by small children andmay present risk of injury.• Once HDTV is positioned, remove theprotective film covering front cabinet.SPECIFICATIONSNOTE: Design and specifications aresubject to change without notice.Power Requirement:Source: AC 120V, 60HzAC Power Consumption: 75 wattsWeight: 24.9 lbs.Dimensions _________________________WIDTH HEIGHT DEPTHw/stands 35.0 22.9 8.8w/out stands 35.0 21.1 2.6NOTE: Dimensions are in inchesSANYO television cus-tomers should contact MRMRecycling at 888-769-0149 orvisit their website atwww.mrmrecycling.comregarding SANYO’s wastemanagement plan.GETTING STARTEDHook up your antenna or your cableservice to the HDTV’s ANT terminalwith the use of a 75 OHM coaxial cable.NOTE: Keep your indoor antenna atleast 3 ft. away from the televi-sion set and any other electron-ic equipment.The tuner in this HDTV can receive:• Digital and Analog off air signalsfrom an antenna• Analog or ClearQAM cable channelsfrom a direct Cable TV connection.ANTENNA CONNECTION FOROFF-AIR SIGNALS OR CABLEANTENNACABLEANALOG / DIGITALANTENNA INAV INPUT SELECTIONPress the INPUT key to select thecorrect AV input for the video sourceyou wish to watch.NOTE: Unused AV inputs may be dis-abled with the Input Setting feature.Finish Setup RepeatChannel Search Result: Succesfully CompletedIf you are having problems, call us toll-free at 1-800-877-5032Analog ChannelsVideo HDMI 1 HDMI 2Digital Channels16 26HDMI 3Before proceeding, please makesure to correctly hook up yourantenna or cable connection andall AV equipment to your HDTV.1. PLUG IN AC POWER CORD120V AC, 60Hz2. TURN ON TV3. TV SET LOCATION SELECTION:Select “Home Mode” to set theHDTV’s backlight to an Energy Starqualified level, or select “StoreMode” to set the backlight to a retaildisplay level.4. CHANNEL AND SIGNAL SEARCH:Select “Signal Search” and pressENTER to perform a channel searchfrom an Antenna or a direct Cableconnection, and a signal searchfrom devices hooked up to theHDTV’s AV input jacks.5. SIGNAL SEARCH RESULT SCREENThe final setup screen displays ana-log and digital channels found, aswell as AV inputs detected.SelectFinish Setup and pressENTER.NOTE: If you wish to repeat theprocess, select Repeat.INITIAL CHANNEL SEARCHNeed help? www.sanyoctv.com 1-800-877-5032 Need help? www.sanyoctv.com 1-800-877-50321JC0P1P0061- -Part No.:Owner’sManual(English)© 2013 Sanyo Manufacturing Corporation1080p HDTV LCDclass(38.5” diagonal)39”LED Model:DP39E231080p HDTV LCDAs an Energy Star ® Partner, SanyoManufacturing Corporation hasdetermined that this productmeets the Energy Star ® guidelinesfor energy efficiency.ENERGY STARTRADEMARKS ________Manufactured under license from DolbyLaboratories. “Dolby” is a trademark ofDolby Laboratories.HDMI, the HDMI Logo and High-DefinitionMultimedia Interface are trademarks or regis-tered trademarks of HDMI Licensing LLC inthe United States and other countries.HDTV INPUT/OUTPUT REFERENCE ________________________________________HDTV SIDE PANELANT Analog / Digital Antenna InputHook up your indoor or outdoor digital antenna, or a directCable service (Analog or ClearQAM).VIDEO INPUT (COMPONENT/COMPOSITE combo)COMPOSITE ConnectionA Composite connection is used to hookup your analogequipment such as a VCR or an older DVD player.Match the YELLOW connector from your external device tothe GREEN Y-VIDEO jack on the HDTV.NOTE: Use the WHITE and RED (L and R) jacks for AUDIOsignal.COMPONENT ConnectionA Component connection will accept SDTV, EDTV andHDTV video signals. Use it for great image quality from di-gital devices such as a DVD player or Video Game system.Match your digital device’s Component output jacks to theComponent input jack set on your HDTV.NOTE: Use the GREEN (Y), BLUE (Pb) and RED (Pr) jacks for theVIDEO signal and the WHITE and RED (L and R) jacks forthe AUDIO signal.HDMI (INPUT1 or INPUT2)Use HDMI INPUT1 & 2 to hookup HD digital devices such asa Blu-ray player, HD Cable Box, HD Satellite Receiver orVideo-game System.Connect your digital device’s HDMI output to any of the two(2) HDMI inputs on your HDTV’s side panel with the use ofan HDMI cable.NOTE: A DVI connection is possible via the HDMI (DVI) INPUT1using an appropriate cable or adapter and connecting theaudio to the L and R (VIDEO INPUT) jacks.USBUSB input jack is used to connect a USB mass storagedevice to watch digital images stored in JPEG format.DIGITAL AUDIO OUT (Coaxial)Hookup a multichannel receiver with the use of a phono-type digital audio cable.HDMI (INPUT3)Use HDMI INPUT3 to hookup HD digital devices such as aBlu-ray player, HD Cable Box, HD Satellite Receiver orVideo-game System.Connect your digital device’s HDMI output to the HDMI3input on your HDTV with the use of an HDMI cable.123456Printed in Mexico, August 2013US3B / 39-Z7ZA / GXFASanyo Manufacturing Corp.2001 Sanyo Avenue, San Diego, CA 921541. Read these instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5. Do not use this apparatus near water.6. Clean only with dry cloth.7. Do not block any ventilation openings. Install in accordancewith the manufacturer’s instructions.8. Do not install near any heat sources such as radiators, heatregisters, stoves, or other apparatus (including amplifiers) thatproduce heat.9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider thanthe other. A grounding-type plug has two blades and a thirdgrounding prong. The wide blade or the third prong are providedfor your safety. If the provided plug does not fit fully into your out-let, consult an electrician for replacement of the obsolete outlet.10. Protect the power cord from being walked on or pinched par-ticularly at plugs, convenience receptacles, and the pointwhere they exit from the apparatus.11. Only use attachments/accessories specified by themanufacturer.12. Use only with the cart, stand, tripod, bracket,or table specified by the manufacturer, or soldwith the apparatus. When a cart is used, usecaution when moving the cart/apparatuscombination to avoid injury from tip-over.13. Unplug this apparatus during lightning storms or when unusedfor long periods of time.14. Refer all servicing to qualified service personnel. Servicing isrequired when the apparatus has been damaged in any way,such as power-supply cord or plug is damaged, liquid has beenspilled or objects have fallen into the apparatus, the apparatushas been exposed to rain or moisture, does not operate nor-mally, or has been dropped.15. If an outside antenna is connected to the television equipment,be sure the antenna system is grounded so as to provide someprotection against voltage surges and built up static charges.In the U.S. Selection 810-21 of the National Electrical Code pro-vides information with respect to proper grounding of the mastand supporting structure, grounding of the lead-in wire to anantenna discharge unit, size of grounding conductors, locationof antenna discharge unit, connection to grounding electrodes,and requirements for the grounding electrodes.16. An outside antenna system should not be located in the vicini-ty of overhead power lines or other electrical light or powercircuits, or where it can fall into such power lines or circuits.When installing an outside antenna system, extreme careshould be taken to keep from touching such power lines or cir-cuits as contact with them might be fatal.EXAMPLE OF ANTENNA GROUNDING ACCORDINGTO NATIONAL ELECTRICAL CODE, ANSI/NFPA 70“Note to CATV system installer:This reminder is provided to call the CATV system installer’sattention to Article 820-40 of the NEC that provides guidelines forproper grounding and, in particular, specifies that the cableground shall be connected to the grounding system of the build-ing, as close to the point of cable entry as practical.”17. Wall or Ceiling Mounting—The product should be mounted toa wall or ceiling only as recommended by the manufacturer.18. Apparatus shall not be exposed to dripping or splashing, and noobjects filled with liquids, such as vases, shall be placed on it.19. When the MAINS plug is used as the disconnect device, thedisconnect device shall remain readily operable.RISK OF ELECTRIC SHOCK DO NOT OPEN!CAUTION: TO REDUCE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NOUSER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A RISKOF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT.THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND MAINTE-NANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THIS UNIT.WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.IMPORTANT SAFETY INSTRUCTIONSCAUTIONFCC INFORMATION ________________________________________________This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment gen-erates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harm-ful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interference by one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.– Consult the dealer or an experienced radio/TV technician for help.CAUTION: FCC Regulations state that improper modifications or unauthorized changes to this unit may void the user’s authority tooperate the unit.This equipment is a Class II or double insulated electrical appliance. It has been designed in such a way that it does not requirea safety connection to electrical earth.Install two (2) “AA” batteries (notincluded) in the remote control.PRECAUTIONS:• Replace both batteries at the sametime. Do not use a new battery with aused battery.• There’s a risk of explosion if a batteryis replaced by an incorrect type.• Keep away from moisture.• Be sure to match the “+” and “–”signs on the batteries with marksinside the remote control.• Please properly dispose of used upbatteries.WARNING: The batteries (or batterypack) shall not be exposed to excessiveheat such as sunshine, fire or the like.BATTERY INSTALLATIONENERGY STAR is a set of power-saving guidelines issued by the U.S. Environmental ProtectionAgency (EPA). ENERGY STAR is a joint program of the U.S. Environmental Protection Agency andthe U.S. Department of Energy helping us all save money and protect the environment throughenergy efficient products and practices.Changes to default as-shipped television configuration and settings or enabling certain optionalfeatures and functionalities will change the energy consumption of the television, this mayincrease energy consumption beyond the limits required for ENERGY STAR qualification.HDTV BACK PANELHDMI VIDEO INPUTAUDIO INPUTHDMI(DVI)(DVI AUDIO)(VIDEO)ANTENNA /CABLE IN2 1123HDMI3DIGITALAUDIO OUTPUT564NOTE: Skip these steps if you are wallmounting the TV.1 Place HDTV face down on apadded or cushioned flat surfaceto protect the screen and finish.2 Carefully insert the stand base tothe bottom of the HDTV and secureit by inserting the four (4) smallerscrews (M4 4x8) as indicated in thediagram below.3 Position the HDTV on a firm andflat surface with adequate spacefor proper ventilation.STAND ASSEMBLY ______WALL MOUNTING (OPTIONAL)Wall mounting of the HDTV must beperformed by a skilled person.If stand base disassembly is required:• Place HDTV face down on a padded orcushioned flat surface to protect thescreen and finish.• Remove the four (4) screws securingthe foot stand. CAUTION: Press downon the two (2) clips on the stand basebottom to unhinge.Use the four (4) larger screws (M66x16) included in the literature packageto secure the HDTV to a wall mountingkit (not included.)IMPORTANT: Wall mount kitmust comply with VESA standard200 x 200. All four (4) screws mustbe threaded to the wall mountand HDTV’s back cabinetMounting screws measurements:M6 (6mm) Diameter, Length—16mm(maximum) |
Related manuals for Sanyo DP39E23
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine