Sanyo DP42410 Owner's Manual

Sanyo DP42410 Owner's Manual Manual pdf 13 page image

13EnglishNOTE: Before connecting any cables, disconnectthe AC Power Cords of both the HDTV andPersonal Computer from the AC outlets.1 Connect an RGB cable from the monitor outputon your PC to the RGB connector on the HDTV andtighten the screws. (Monitor Cable not supplied).2 Insert one end of a Stereo Mini-Audio cable into thePC Audio Out jack and the other end into the HDTVPC AUDIO INPUT jack. (Stereo Mini-Audio Cable notsupplied).HINT: Volume can be adjusted both from the PC and theHDTV VOLUME +, and - buttons.3 Select Auto Adjustment from the PC Setup Menu.NOTE: Power on the HDTV and any otherperipheral equipment before powering on thecomputer.PC MENU NAVIGATION MAPPC MONITOR OPERATIONPC PREPARATIONTo avoid a “No Support” condition, preset your PC’soutput resolution to an XGA value, such as, 1024 x 768,before you disconnect it from your regular monitor.PC MENU- AUTO ADJUSTMENTSOPERATION1 Use the CURSOR Ÿ(UP) and ź(Down) buttonson the remote control to highlight the Auto Adjustin the PC menu mode. Press the OK button.2 Highlight Auto Adjust and press the OK button tostart the automatically adjust function.PC MENU- MANUAL ADJUSTMENTSOPERATIONThe Clock, Phase, Horizontal Position, and VerticalPosition are set automatically when Auto Adjustment iscompletely done.Clock- Adjust the Dot frequency to match the dotfrequency of your computer.Phase- Adjust the phase when the picture appears toflicker or blur.H-Position- Move the image horizontally.V-Position- Move the image vertically.1 Use the CURSOR Ÿ(UP) and ź(Down) buttonson the remote control to highlight H-Position,V-Position, Clock or Phase. Press the OK button.2 Use the CURSOR ŻŹEXWWRQVWRDGMXVWWKHsetting value. Press the MENU button to return.3 Press the EXIT button on the remote control toexit the current menu.PC MENU OPERATING TIPSThe Picture settings in the PC input do not affect otherinput settings.PC CONNECTIONS