5Need help? www.sanyoctv.com 1-800-877-5032GETTING STARTEDInstall two (2) “AAA” batteries in the remotecontrol. (Not included)To ensure safe operation, please observe thefollowing precautions:• Replace both batteries at the same time. Do not use anew battery with a used battery.• There’s a risk of explosion if a battery is replaced byan incorrect type.• Do not expose the Remote Control unit to moistureor heat.• Be sure to match the “+” and “–” signs on thebatteries with marks inside the remote control.ANTENNA CONNECTION FOROFF-AIR SIGNALS OR CABLEANTENNACABLEANALOG / DIGITALANTENNA INBATTERY INSTALLATIONHook up your antenna or your cable service tothe HDTV’s ANT terminal with the use of a 75OHM coaxial cable.NOTE: Keep your indoor antenna at least 3 ft. awayfrom the television set and any other electronicequipment.The tuner in this HDTV can receive:• Digital and Analog off air signals from an antenna• Analog or ClearQAM cable channels from a directCable TV connection.1 Place HDTV face down on a padded orcushioned flat surface to protect the screenand finish2 Remove the four (4) screws securing the footstand. CAUTION: Hold the stand firmly as youremove the last screw.STAND REMOVAL ____________1 Place HDTV face down on a padded orcushioned flat surface to protect the screenand finish2 Carefully insert the stand base to the bottomof the HDTV and secure the base by inserting4 screws as indicated in the above diagram.NOTE: If your HDTV came packed with the Stand Baseunassembled, these screws will be found in theliterature package.STAND ASSEMBLY ___________Wall mounting of the HDTV must be performedby a skilled person.Use the screws that are threaded into four (4) ofthe six (6) inserts on the back of your PlasmaHDTV to secure it to a wall mounting kit (notincluded.)VESA standard interface: 480 x 200 and 480 x 360Mounting screws measurements:M6 (6mm) Diameter, Length—12mm (maximum)WALL MOUNTING ____________