Sanyo DP55360 Owner's Manual

Also see for DP55360 - 55"Class LED LCD HDTV: Application guide Service manual

Contents

5Need help? www.sanyoctv.com 1-877-864-96041 Remove the two (2) screws holding the standbase cover and carefully dislodge.STAND REMOVAL AND WALLMOUNTING (OPTIONAL)Tools Needed: Phillips screwdriverIMPORTANT NOTE: Place HDTV face downon a padded or cushioned flat surface toprotect the screen and finish.Wall mounting of the HDTV must be performedby a skilled person.GETTING STARTEDInstall two (2) “AAA” batteries in the remotecontrol. (Not included)To ensure safe operation, please observe thefollowing precautions:• Replace both batteries at the same time. Do not use anew battery with a used battery.• There’s a risk of explosion if a battery is replaced byan incorrect type.• Do not expose the Remote Control unit to moistureor heat.• Be sure to match the “+” and “–” signs on thebatteries with marks inside the remote control.ANTENNA CONNECTION FOROFF-AIR SIGNALS OR CABLEANTENNACABLEANALOG / DIGITALANTENNA INBATTERY INSTALLATIONHook up your antenna or your cable service tothe HDTV’s ANT terminal with the use of a 75OHM coaxial cable.NOTE: Keep your indoor antenna at least 3 ft. awayfrom the television set and any other electronicequipment.The tuner in this HDTV can receive:• Digital and Analog off air signals from an antenna• Analog or ClearQAM cable channels from a directCable TV connection.2 Remove the four (4) screws securing thestand base to the HDTV. CAUTION: Hold thestand firmly as you remove the last screw.3 Use the screws that are threaded into the four(4) inserts on the back of your HDTV to secureit to an appropriate wall mounting kit.VESA standard interface: 400 x 400Mounting screws measurements:M6 (6mm) Diameter, Length—12mm (maximum)NOTE: Wall mounting kit is not included.