11HELPFUL HINTS (Problems/Solutions)Before calling for assistance, please check the condition that most closely resembles your problem in thefollowing chart, then try the solutions for that condition. Visit our Web site at www.sanyoctv.comor call toll free 1-800-877-5032. Press POWER key. Sleep Timer may have been set. Unplug TV for a few seconds. Adjust antenna. Try a different channel. Select Auto from the on-screen menuor press RESET key. Turn off Mixer, Drill, Blender, etc. Press RESET key. Switch OFF Captions (see page 8). Try a different channel. Adjust antenna. Select Auto from Picture on-screenmenu or press RESET key. Try a different channel. Adjust Volume. Select Cable from on-screen menu; thenstart CH. (channel) Search using Menu. Select VHF/UHF from on-screen menu;then start CH. (channel) Search usingmenu. Select CH. Scan Memory and manuallyadd channels or start channel search. Press RESET key to clear setting. Set V-Guide to OFF or press theRESET key. Select Caption1 or Caption2(see page 8). Reselect your menu language choiceusing the on-screen menu. Replace batteries. Aim remote control at front of TV.TV turns off by itself.No picture, poor picture, orwavy lines in picture.Black boxon screen.Poor color or no color.No sound, poor sound.No Cable channelsabove number 13.No UHF channels,VHF OK.Cannot select or scansome channels.No Captioning.Menu System words seemmisspelled.Remote Control willnot work.Cabinet makes poppingsound. Check signal (Cable/Ant.) connection. Power surge protection feature. Check antenna connections. May be station trouble. Brightness or Contrast misadjusted. Possible interference from householdappliance. TV station is broadcasting a Captiontext signal without any textual data. Check if program is in color. Check antenna connections. Color or Tint misadjusted. May be station trouble. May be station trouble. May be MUTE function. Cable Channel Indicator C shouldappear next to channel number. Cable Channel Indicator C should notappear next to channel number. Channel may be removed frommemory. Check antenna connections. V-Guide is set to block programming.(See pages 9 ~ 10.) Tune to a station that is broadcasting aClosed-Caption signal. Maybe a foreign language isselected. Check batteries. Check if TV set is plugged in.Problem: Check these Conditions: Try these Solutions: This is a normal condition during warm-up and cool down ofthe plastic cabinet parts.CARE AND CLEANINGThe surface of the cabinet can be damaged if not properly maintained. Many common household aerosolsprays, cleaning agents, solvents, and polishes will cause permanent damage to the fine surface.1. Unplug the power cord before cleaning the television.2. Clean the screen and cabinet with a soft dry cloth.Note: Never spray liquids on the screen because it can run down and drip onto the chassis.This may cause component failure not covered under Warranty.