— 10 —SERVICE HINTSPOWER FAILURE DETECTORThis unit is equipped with a Power Failure Detector function included in the CPU which checks for an abnormal condition inthe chassis power supplies, including the power supply derived from the Horizontal Output Transformer.If, while the power is on, a failure is caused by any of the following that results in a low voltage supply, the CPU will turn theunit off in 1.5 seconds to prevent unnecessary damage:• Failure within the power supply circuits.• A short circuit in the load side from the supply.• Stoppage of the Horizontal Output Oscillator caused by the X-Radiation protection Hold-Down Circuit.If, while the power is off, the power is switched on and any of these failures remains uncorrected, the CPU will shut off thepower within 3 seconds.Check the following if the unit is turned off by the power failure detector.1. Disconnect the AC power cord (120V AC line) for at least 10 seconds.2. Connect a DC Voltmeter to the following TEST POINTS.3. Press the Power key and check for the proper voltage supplies.4. If any of these voltages is low, the power failure detector should turn the unit off within 3 seconds.5. Check all circuits listed above.Note: This unit is equipped with a Power Surge Protection feature included in the CPU. If power failure occurs three timeswithin 15 minutes, the CPU will automatically stop functioning to help prevent secondary damage. (TV will not turn onby pressing the power key.) To reset the operating programs within the CPU, disconnect the AC power cord for at least10 seconds.TJ4 26VTJ6 5VD429 Cathode 5V