RECORDING38 EnglishOPERATIONUse the following procedure to automatically record alarmvideo to the alarm recording area when an alarm signal isdetected.1 Set alarm recording.Set “7. ALARM REC MODE SET” from .(See INSTRUCTION MANUAL.)2 Press the [EXIT] button.The setting procedure is ended and the normal screen isdisplayed.z When an alarm signal is detected, “ALARM” flashes inthe operation display and the alarm recording starts(indicated by “REC”).z Alarm video is recorded to the alarm recording area.z Whenever an alarm occurs, the number of alarms asindicated in the operation display is incremented.z If an alarm occurs during normal recording or timerrecording, the recording operation will be ended.3 End alarm recording.When the alarm duration has expired (default setting: 20seconds), both “REC” and “ALARM” finish flashing fromthe operation display and recording stops.z When the space remaining in the alarm recording areadrops below a preset value, the FULL indicator on thedigital video recorder’s front panel starts to flash. Ifrecording is continued beyond this point, the alarmrecording area will become full, recording will stop, andthe FULL indicator will stop flashing and remain lit. Insuch a case, use the menuto perform “AREA FULL RESET” for the alarmrecording area, thus allowing recording to start againfrom the beginning. (See INSTRUCTION MANUAL.)Alarm recordingWhen an alarm signal is detectedEXIT01-01-04 00:00:00 REC REPEAT EN A ALARM 000002Counts the numberof alarms.