2BEFORE YOU CAL FOR SERVICEIf the oven fails to operate:A) Check to ensure that the oven is plugged insecurely. If it is not, remove the plug from theoutlet, wait 10 seconds and plug it in againsecurely.B) Check for a blown circuit fuse or a trippedmain circuit breaker. If these seem to beoperating properly, test the outlet with an otherappliance.C) Check to ensure that the control panel isprogrammed correctly and the timer is set.D) Check to ensure that the door is securelyclosed engaging the door safety lock system.Otherwise, the microwave energy will not flowinto the oven.IF NONE OF THE ABOVE RECTIFIES THE SITUATION, THEN CONTACT A QUALIFIEDTECHNICIAN. DO NOT TRY TO ADJUST OR REPAIR THE OVEN YOURSELF.INSTALLATION1. Make sure that all the packing materials are removed from the inside of the door.2. WARNING: Check the oven for any damage, such as misaligned or bent door, damaged doorseals and sealing surface, broken or loose door hinges and latches and dents inside the cavity oron the door. If there is any damage, do not operate the oven and contact a qualified servicepersonnel.3. This microwave oven must be placed on a flat, stable surface to hold its weight and the heaviestfood likely to be cooked in the oven.4. Do not place the oven where heat, moisture, or high humidity are generated, or near combustiblematerials.5. For correct operation, the oven must have sufficient airflow. Allow 20cm of space above the oven,10cm at back and 5cm at both sides. Do not cover or block any openings on the appliance. Do notremove feet.6. Do not operate the oven without glass tray, roller support, and shaft in their proper positions.7. Make sure that the power supply cord is undamaged and does not run under the oven or over anyhot or sharp surface.8. The socket must be readily accessible so that it can be easily unplugged in an emergency.9. Do not use the oven outdoors.10. Please be advised that these Sanyo Microwave Ovens are not to be installed or used within anenclosed cabinet.