Sanyo H1340 - ECD Radio / CD Player Operating Instructions Manual

Contents

ACCESSORIESPlease retain the carton and packing materials, as this is the best protection for theunit should it be necessary to return it for servicingCheck the packing carefully for the following accessories(1) 1 x l#mounting bracket (used to fix unit to car, see installation method B)(2) 2 x 2#mounting bracket (used to fix unit to car, see installation method B)(3) 1 x 3#mounting bracket (used to fix unit to car, see installation method B)(4) 1 x right bracket (used for “GM” car)(5) 1 x left bracket (used for “GM” car)(6) 8 x screw 3x4mm(used to fix mounting bracket (l#, 2#, 3#) to unit, see installation method B)(7) 4 x quickie bolt 5x1 Omm (used to fix unit to car, see installation method A)(8) 1 x quickie bolt 5xl8mm (used to fix unit to car, see installation method A)(9) 1 x screw 2xl2mm (used to secure the front panel for anti-theft purposes)(10) 5 x hexagon nut (used to quickie bolt)(11) 4 x screw 4x1 Omm (used to right/left bracket)6) (4& t2) 6 t3) & 14) @1#mounting bracket 2#mounting bracket 3#mounting bracket right bracket(5) (6) (7) 03)@mleft bracket screw quickie bolt quickie bolt(9) (10) (11)a3 &screw hexagon nut screwCAUTIONl This unit is designed to operate on 12 volts DC, negative ground electrical systemsonlyl When fuse replacement is necessary, use only a 15 amp fuse Do not replace witha higher rated fuse If the fuse blows often, carefully check all electrical connectionsfor any short circuits and have your car’s voltage regulator checked alsol Do not install the unit where it will be exposed to direct sunlight or hot air dischargedfrom the car heaterl Do not expose the unit to water or moisturel This AM/FM Radio with CD Player should not be adjusted or repaired by anyoneexcept qualified service personnel If servicing is required, return the unit to anauthorized SANYO mobile audio dealerl Changes or modifications not expressly approved by SANYO may void the user’sauthority to operate this equipmentl This device complies with Part 15 of the FCC Rules Operation is subject to thefollowing two conditions(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference thatmay cause undesired operation1