Sanyo HEC-DR8700 Instruction Manual

Also see for HEC-DR8700: Service manual

Contents

Sanyo HEC-DR8700 Instruction Manual Manual pdf 11 page image

10HOW TO INSTALL THE STANDTools needed: Phillips (crosshead) screwdriverInstallationscrewsHand screwRemove the cover attached to theright face of the right arm rest.Reattach the cover to the rightside of the arm rest.Screwdriver is not included.Installation screws are included in the accessorybox. (See page 6)CoverGently pull the lower portionof the cover toward you.Press the lowerportion of thecover until youhear a click.Place the remote control in the remote control standas indicated by arrows ① and then push it in thedirection of arrow ②.Put the remote control on theremote control stand (upper part).Put the sensor controller on thesensor controller stand (lower part).Secure the stand on the right-handside of the arm rest, using theinstallation screws (3 screws).Place the sensor cable into the hookon the left side of the sensor stand.Place the remote control cable intothe hook on the right side of thesensor stand.②①RemotecontrolSensorcontrollerRemote controlstandSensor controllerstandIf the remote controlstand moves tooloosely, tighten thehand screw.Remote control cordHook123456StopperAttach so that thestopper is set intothe top of the hook.Sensor controllercordHook