Sanyo LCD-46XZ10FH Service Manual

Also see for LCD-32XZ10: Instruction manual

Contents

4 User menu setup before leaving factoryEnter into page “LOCK” of user menu, select submenu item “Restore Factory Default” to presetitems before leaving factory as below:a) Clear out all programs information;b) Clear out information of parental control (VCHIP);c) Default setup of user analog data;d) Set Menu Language as English;e) Set Power on MODE as Off.Instruction of factory software burning as Table 6Table 6 Instruction of factory software burningNo. Part No. Part typeInstruction ofsoftwarefunctionBurnedbeforeSMTBurning methodN111 5272564002 EN25Q64-104HIP FLASH Yesburned with programALL11, write-protect setup,refer to Note 1 in detailN108 5272404002 AT24C04 HDMI KEY Yes burned with program ALL11NA04 5272402002 AT24C02 HDMI EDID Yes burned with program ALL11NA05 5272402002 AT24C02 HDMI EDID Yes burned with program ALL11NA06 5272402002 AT24C02HDMI EDID(supportingthe 3rd HDMI)Yes burned with program ALL11N106 5272402002 AT24C02 VGA EDID Yes burned with program ALL11Note 1: Write-protect setup methodEnter into burning interface of program ALL-100, select item “Config”, press item “configSetting”, set item “Protect” as “All Protect”; be sure to select item “Config” before burningsoftware, and write-protect must be re-set after burning program ALL-100 startup every time.Note 2: Burning and upgrading software method with burning tool ISPMethod of software upgrading