Sanyo PLC-EF60 Service Manual

Also see for PLC-EF60: Owner's manual Specifications

Contents

- 9 -ORDER REPLACEMENT LAMPType No. Service Parts No.POA-LMP60 610 315 7689Lamp ReplacementCAUTION :DO NOT OPERATE A PROJECTOR WHILE ANY OF LAMPSIS REMOVED. IT MAY RESULT IN MALFUNCTIONS, FIREHAZARD, OR OTHER ACCIDENTS.When the life of the projection lamp of this projector drawsto an end, the LAMP1/2 REPLACE indicator lights yellow. Ifthis indicator lights yellow, replace the lamp with a new onepromptly.HandleLamp coversFor continued safety, replace with a lamp of thesame type. Do not drop a lamp or touch a glassbulb! The glass can shatter and may cause injury.Allow a projector to cool, for at least 60 minutes be-fore you open the Lamp cover. The inside of theprojector can become very hot.Top ControlCAUTIONScrewsHandleScrewsNotes on Lamp Replacement:To maintain quality of picture (better balance of colorand brightness in the entire screen), we recommendreplacing all 2 lamps at a time.These indicators light yellowwhen the life of the projectionlamp draws to an end.LampsFollow these steps to replace the lamp.1 Turn off the projector and disconnect the AC plug. Allowthe projector to cool for at least 60 minutes.2 Loosen each screws on the lamp covers with a screw-driver, and remove them.3 Loosen 4 screws of the lamps with a screwdriver and pullout one lamp and another with grasping the handle.4 Replace the lamps with new ones and tighten the 4 screwsback into position. Make sure that the lamps are set prop-erly. Replace the lamp covers and tighten the screws.5 Connect the AC power cord to the projector and turn onthe projector.6 Reset the Lamp replace counter.See "How to reset the Counter Timer".