Sanyo PLC-WL2500 Owner's Manual

Also see for PLC-WL2500: Command list Manual Manual Owner's manual Brochure

Contents

Sanyo PLC-WL2500 Owner's Manual Manual pdf 13 page image

1Positioning the ProjectorFor projector positioning, see the figures below. The projector should be set perpendicularly to the plane of thescreen. The projector will focus at distance from 2.09' to 3.93' (63.6 cm to 119.7 cm).InstallationNote:• This projector is not equipped with an optical zoom. To adjust the screen size, change the throw distance.• The brightness in the room has a great influence on picture quality. It is recommended to limit ambientlighting in order to obtain the best image.• All measurements are approximate and may vary from the actual sizes.Adjustable FeetProjection angle can be adjusted up to 10.0 degrees with theadjustable feet.Rotate the adjustable feet and tilt the projector to the properheight; to raise the projector, rotate the both feet clockwise.To lower the projector or to retract the adjustable feet, rotatethe both feet counterclockwise.To correct keystone distortion, press the KEYSTONEbutton on the remote control or on the top control or selectKeystone from the menu (see pages 23, 46).Adjustable Feetāāā$3.93' (119.7 cm)2.83’ (86.1 cm)2.09’ (63.6 cm)(Inch Diagonal)Screen Size(W x H) mm16:10aspect ratio60” 80” 110”1292 x 808 1723 x 1077 2369 x 1481Throw distance 2.09’ (63.6 cm) 2.83’ (86.1 cm) 3.93' (119.7 cm)A 7.9” (20.0 cm) 9.7” (24.5 cm) 12.3” (31.3 cm)