Sanyo PLC-WL2500 Service Manual

Also see for PLC-WL2500: Command list Owner's manual Manual Manual Owner's manual

Contents

Sanyo PLC-WL2500 Service Manual Manual pdf 8 page image

-8-Lamp ReplacementWhen the projection lamp of the projector reaches its endof life, the Lamp replacement icon appears on the screenand LAMP REPLACE indicator lights yellow. Replace thelamp with a new one promptly. The timing when the LAMPREPLACE indicator should light is depending on the lampmode.For continued safety, replace with a lamp of thesame type. Do not drop a lamp or touch a glassbulb! The glass can shatter and may cause injury.Allow a projector to cool for at least 45 minutesbefore you open the Lamp Cover. The inside ofthe projector can become very hot.CAutIONCAutIONFollow these steps to replace the lamp.Turn off the projector and unplug the AC power cord. Letthe projector cool for at least 45 minutes.Loosen the three (3) screws that secure the lamp. Liftthe lamp out of the projector by using the handle.13Replace the lamp with a new one and secure the three(3) screws. Make sure that the lamp is set properly.Close the lamp cover and secure the screw.4Loosen the screw and open the lamp cover.2Connect the AC power cord to the projector and turn onthe projector.6 Reset the lamp counter.See “Resetting the Lamp Counter” on the next page.5Order rePLACeMeNt LAMPReplacement lamp can be ordered through your dealer. When ordering a projection lamp, give the followinginformation to the dealer.replacement Lamp type No. : POA-LMP141Service Parts No. : 610 349 0847top PanelWhen replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be bro-ken. If replacing the lamp of a projector which has been installed on the ceiling, you should always assumethat the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove thelamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass getinto your eyes or mouth, seek medical advice immediately.CAutIONLamp replacement iconWArNING:TURN OFF THE UV LAMP BEFOREOPENING THE LAMP COVERThis indicator turns yellowwhen the projection lampreaches the end of its life.Note:The Lamp replacement icon will not appear when theDisplay function is set to Off, during Freeze, or No show.Maintenance