Sanyo PLC-WTC500L Service Manual

Also see for PLC-WTC500L: Owner's manual Manual Manual Command list Brochure

Contents

Sanyo PLC-WTC500L Service Manual Manual pdf 12 page image

-12-MaintenanceLamp ReplacementWhen the total lighting time of a Projection Lamp reaches therecommended total hours of use, the Lamp replacement iconappears on the screen and LAMP 1 / 2 REPLACE indicatorlights yellow. Replace the lamp with a new one promptly. Thetiming when the LAMP 1 / 2 REPLACE indicator should lightis depending on the lamp mode.Follow these steps to replace the lamp.For continued safety, replace with a lamp of the sametype lamp. Do not drop the lamp or touch the glassbulb! The glass can shatter and may cause injury.Allow a projector to cool for at least 45 minutesbefore you open the Lamp cover. The inside ofthe projector can become very hot.cAutIoNTurn off the projector and unplug the AC power cord.Let the projector cool for at least 45 minutes.Lift the lamp out of the projector by using the handle.Replace the lamp with a new one. Make sure that thelamp is set properly. Put the lamp cover back and se-cure it with the screw.Remove the screw that secures the lamp cover with acoin, and then open the lamp cover.cAutIoNScrewLamp replacement iconTop ControlLAMP 1/2 rePLAceindicatorsLamp coverNote:•The Lamp replacement icon will not appearwhen the Display function is set to “Off”, or dur-ing “Freeze”.Check the number of lamp to be replaced on the LampStatus Display or the LAMP 1/2 REPLACE indicatorsand replace the lamp.HandleLamp 1Lamp 2When replacing the lamp because it has stopped illuminat-ing, there is a possibility that the lamp maybe broken. Ifreplacing the lamp of a projector which has been installedon the ceiling, you should always assume that the lampis broken, and you should stand to the side of the lampcover, not underneath it. Remove the lamp cover gently.Small pieces of glass may fall out when the lamp coveris opened. If pieces of glass get into your eyes or mouth,seek medical advice immediately.CAUTIONNote:• After lamp replacement, make sure to check the Lamp mode.12345order rePLAceMeNt LAMPtype No. PoA-LMP125Service Parts No.: 610 342 2626