Sanyo PLC-XD2200 - XGA Able Multimedia Projector Manual

Also see for PLC-XD2200: Owner's manual Easy setup Manual Command list Dimensional drawing

Contents

PLC-XD2200/2600 Expand Serial Command Functional Specifications23 / 718.5.4 CF_H – POS CommandCommand “CF_H-POS_%1”[CR]%1“0000~nnnn” --- Directly select Horizontal Position setting value“nnnn” shows maximum value, it is current Total Dots value - Display Dots value“UP” -------------- Current Horizontal Position setting value + 1“DN” -------------- Current Horizontal Position setting value - 1DetailsSet Horizontal Position value of PC signal.Projector does not save the value set with this command so that it resets whenprojector turning into Standby status or ALL is OFF.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.5.5 CF_V – POS CommandCommand “CF_V-POS_%1”[CR]%1“0000~nnnn” --- Directly select Vertical Position setting value“nnnn” shows maximum value, it is current Total Line value - Display Line value“UP” -------------- Current Vertical Position setting value + 1“DN” -------------- Current Vertical Position setting value – 1DetailsSet Vertical Position value of PC signalProjector does not save the value set with this command so that it resets whenprojector turning into Standby status or ALL is OFF.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.5.6 CF_DDOTS CommandCommand “CF_DDOTS_%1”[CR]%1“0256”~”nnnn” --- Directly select Display Dots setting value“nnnn” shows maximum value, it is current Total Dots value - HorizontalPosition valueEven number is available and when odd number is set, it is rounded out.“UP” -------------- Current Display Dots setting value + 2“DN” -------------- Current Display Dots setting value – 2DetailsSet Display Dots value of PC signalProjector does not save the value set with this command so that it resets whenprojector turning into Standby status or ALL is OFF.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]