Sanyo PLC-XD2200 - XGA Able Multimedia Projector Owner's Manual

Also see for PLC-XD2200: Owner's manual Easy setup Manual Manual Command list

ENGLISH3. When communication is established correctly, the word "PASSWORD:" appears on thewindow. Type the login password (Network PIN code*2) for the projector and then press"Enter" key on the keyboard. If you do not set up the Network PIN code, just press "Enter"key.When the word "Hello" is replied, login has been succeeded.* The password "1234" is used for the example.4. Type the commands, refer to below table, to control the projector and then press "Enter"key for termination. For example, type "C00" which is a command to turn on the projec-tor, and press "Enter" key. Confirm the projector is turning on.* Enter with ASCII 64-byte capital characters and one-byte characters.To disconnect the communication, press "Ctrl" key and "]" key at the same time, type"close" and then press "Enter" key on the Keyboard.> close [return]The table below shows the typical command lists for controlling this projector and pleaseconsult your local dealer for further information of another commands.*1 Further instructions about the telnet application, please see the on-line guide on your computer.*2 The password is a Network PIN code decided item "Network PIN code setting" (+pp.14, 23). If theauthentication of the entered password is failed 4 times continuously, the communication will bedisconnected automatically. Please try again for the connection.✐ If the password or any command is not entered for more than 30 seconds, the communication willbe disconnected automatically. Please try again for the connection.Command FunctionC00 Power onC02 Power offC09 Volume upC0A Volume downC0B Audio Mute onC0C Audio Mute offC1C Menu display onC1D menu display offCommand list tableUse of telnet