Sanyo PLC-XU116 Service Manual

Also see for PLC-XU116: Dimensional drawing Specification sheet Manual Manual Brochure

Contents

-20-Optical Parts DisassemblyLCD Panel/Prism Ass’yFig.5-15. LCD Panel/Prism Ass’y removal(M2.5x4)x2(M3x10)(Bottom side)IMPortANt NotIce on lcd Panel/Prism Ass'y replacementLCD panels used for this model can not be replaced separately. Do not disassemble the LCD Panel/Prism Ass’y.These LCD panels are installed with precision at the factory. When replacing the LCD panel, should be replacedwhole of the LCD panels and prism ass’y at once.After replacing LCD Panel/Prism ass’y, please check the following points.- Check that there is no color shading at the top, bottom, left or right of the screen. If there is, try to remove theshading following to the chapter “Optical Adjustment”.- Check the white balance. If it needs the adjustment, adjust the white balance following to the “White Balance ad-justment” , “Gamma adjustment” and “Common Center adjustment” in the chapter “Electrical Adjustment”.- Check the white uniformity on the screen.If you find the color shading at the some part of the screen, it needs to take the color shading adjustment. Thisadjustment should be performed by a computer and it also requires a special software “Projector service tool”. Thesoftware will be supplied separately and can be ordered as follows;ProJector SerVIce tool Ver. 4.20Service Parts No. 610 343 5596