Sanyo PLV-HD100 - 5500 Lumens Owner's Manual

Also see for PLV-HD100: Dimensional drawing Service manual Owner's manual Specifications Manual

37SETTINGOn startWhen this function is “On,” projector is automatically turned on justby connecting AC Power cord to a wall outlet.Note ; Be sure to turn projector off properly (refer to section“TURNING OFF PROJECTOR” on P22). If projector is turnedoff in wrong steps, On Start function does not operateproperly.Power managementTime left until Lamp off.Remote controlThis projector has eight different remote control codes; the factory-set normal code (Code 1) and the other seven codes (Code 2 toCode 8). This switching function prevents remote control operationmixture (jam) when operating several projectors or video equipmenttogether.For example operating projector in “Code 7,” both projector andRemote Control Unit must be switched to “Code 7.”To change the code of Projector;To change the Remote control code of the projector used in ON-SCREEN MENU is selectable from Code 1 to Code 8.To change the code of the Remote Control Unit;While pressing the MENU button, press the IMAGE button number oftimes corresponding to each remote control code number. (Refer toP19.)When pressing SELECT button atRemote control, Remote controlcode Menu appears.This projector is equipped with a power management function. When the input signal is interrupted and any button is notpressed for 30 seconds or more, the power management function operates in order to reduce power consumption andconserve lamp operating time. The factory default settings for power management are "Ready" and "5 Min".The power management function is canceled.When a SELECT button is pressed,the adjustment screen is displayed.Use the POINT LEFT/RIGHT button(s)to select the power managementfunction mode ("Off", "Ready" or "Shutdown").Use the POINT DOWN button to movethe pointer to the time setting, and thenuse the POINT LEFT/RIGHT button(s)to set the time (1 minute to 30minutes).If "Shut down" is selectedIf "Off" is selectedIf "Ready" is selectedOPERATION1) If the input signal is interrupted and any button is not pressed for 30 seconds or more, the message "No signal" and thetimer display appears on the screen. Then the count-down starts for the time being set.2) When the set time is elapsed, the lamp will be switched offand lamp cooling starts. The READY indicator will beswitched off while the lamp cooling is in progress, and theprojector cannot be operated during this time.3) When the lamp cooling is completed, the READY indicatorstarts flashing to notify the operator that powermanagement mode is active. In this condition, the lampwill turn on and images will be projected if a signal startsbeing input or the projector is operated.2) When the set time is elapsed, the lamp will be switched offand lamp cooling starts. The READY indicator will beswitched off while the lamp cooling is in progress, and theprojector cannot be operated during this time.3) When the lamp cooling is completed, the power switchesoff.