Sanyo PLV-HD2000E Owner's Manual

Also see for HD2000 - LCD Projector - 7000 ANSI Lumens: Quick guide Safety manual Instruction manual Instruction manual

Contents

Sanyo PLV-HD2000E Owner's Manual Manual pdf 42 page image

42READYLAMPLAMPREPLACEWARNINGTEMP.AIR FILTER CARE AND CLEANINGTurn power off, and disconnect AC power cord from AC outlet.1234Pull out air filter from a projector.Pulling up center frame of air filter top, separate air filter top andair filter from air filter base.Clean each parts with brush out dust and particles.Assemble sheet and air filter and replace air filter to a projector.5AIR FILTERAIR FILTERTOPAIR FILTERBASE AIR FILTERCAUTIONDo not operate a projector with Air Filter removed. Dustmay accumulate on LCD Panel and Mirror degradingpicture quality.Do not put small parts into Air Intake Vents. It may resultin malfunction of a projector.MAINTENANCEWARNING TEMP. INDICATORVentilation Slots of a projector may be blocked. In such an event, repositiona projector so that Ventilation Slots are not obstructed.Air Filter may be clogged with dust particles. Clean Air Filter by followingsection AIR FILTER CARE AND CLEANING on this page.12If WARNING TEMP. Indicator remains on after performing above checks,Cooling Fans or Internal Circuits may be malfunctioning. Contact the servicestation.3The Warning Temp. Indicator flashes red to let you know the internal temperatureof the projector exceeds the normal level. If the temperature goes up further, theprojector will be turned off automatically and the Ready indicator will go out. (TheWarning Temp. Indicator continues flashing.) After the cooling-off period, theReady Indicator lights on again and the projector can be turned on by pressing theOn/Off button on the remote control unit or on the side control. When you turn onthe projector, the Warning Temp. Indicator will go out.If the Warning Temp. Indicator is still flashing, check the followings;FRONT INDICATORSWhen both of the Warning Temp. and Ready indicators are flashing:Warning Temp.IndicatorReadyIndicatorWhen the projector detects an internal problem, it will shut down automatically and both of the Warning temp. and ReadyIndicators starts flashing. In this condition, the projector cannot be turned on even if you press the On/Off button on theremote control unit or on the side control. If this case happenes, disconnect and reconnect the AC power cord, and then turnon the projector again to check its operation. If the projector shuts down again or fails to be turned on, the internal check andrepair will be required. Plug off the AC power cord and contact service station.WARNINGTEMP.READYLAMPREPLACELAMPREAR INDICATORSAir filters help prevent dust from accumulating on the optical elements inside the projector. To whatever extent the air filtersbecome clogged with dust particles, the cooling fans’ effectiveness is reduced, which may result in an internal heat build-upand adversely affect the life of the projector. Therefore, for appropriate care and use of the projector, regular cleaning of theair filters is necessary.How often the air filters should be cleaned really depends upon the environment in which the projector is being operated. Asa rough guide, under a normally clean operating environment, the air filters should be cleaned approximately every 200hours of use. However, if the projector is being operated in a somewhat dusty or smoky environment, the air filters should becleaned more often; for consistently good projector operation and performance, timely cleaning of the air filters is a veryimportant factor. When appropriate, clean the air filters following the steps below.NOTE: If the dust cannot be removed bycleaning, it is probably time to replacethe air filters with new ones. Pleaseconsult your dealer.Air Filter Parts No. 610 301 4814APPENDIX