Sanyo Projector Owner's Manual

Also see for PLC-HF15000L - 15000 Lumens: Owner's manual Manual Manual Specification sheet

Sanyo Projector Owner's Manual Manual pdf 28 page image

Chapter 3 Basic Setting and Operation● When the brightness (Current value) continuously goes down a certain rate from Targetvalue in Constant mode:✐ This alert mail will be sent when "Lamp mode" is set to "Constant mode".* The brightness (Current value) continuously goes down a certain rate from the value inConstant mode. Check the lamp status and replace the lamp, or decrease Target value inConstant mode.● When PJ needs service:✐ The projector lamp was turned off, because the projector power circuit failed.Unplug the AC power cord and plug it, and then turn on the projector once again to verifyoperation. If the problem still persists, unplug the AC power cord and ask servicing to aqualified service personnel with the error information.Examples: Type and contents of alert mailWhen the projector has an abnormality, the following alert messages are sent to the regis-tered E-mail address according to your selected condition. Administrator or user can takean efficient action quickly by receiving this message. This is very useful to maintain andservice the projector.The following are examples of received messages.● When internal PJ temperature is too high:TITLE: Message from projectorProjector Model Name: model nameTCP/IP: 192.168.1.201 Projector Name: Proj05It sends you following message.* The projector lamp is turned off, because internal temperature goes over the safety limit.Wait for the completion of the cooling process and make sure the projector has beenturned into Standby. Then turn the projector on again.If the Indicator continues flashing, check the air filter for dust accumulation.*Maintenance requirement from Projector is detected.Check up LED status of projector and consult with the dealer.AD, 3.3V OKKS, 3.3V OK--- --- ---MAIN, 3.3V NG--- --- --- Error information● When PJ lamp replacement time is reached:✐ Replace it with a new lamp immediately and reset the lamp counter. If the projector isused without resetting the lamp counter, the alert mail is sent to users in every power-on of the projector. This alert mail will not be sent when unchecking the mail sendingcondition "When PJ lamp replacement time is reached".* The projector lamp 1 has reached replacement time.Lamp 1 ON 2000 hLamp 2 ON 1800 hE-mail Header