Sanyo VCC-XZN600P Installation Manual

Also see for VCC-XZ600P: Brochure Installation manual Instruction manual

Contents

Sanyo VCC-XZN600P Installation Manual Manual pdf 4 page image

3Installation method■ Installing the camera to the ceiling or wallUse commercially-available screws (M8x4) to secure the camera base by the four screw holes (A).Note regarding cable hole in wallWhen installing the camera base, check the position of the cable hole (B) and pull the cable through it.Refer to page 7 for details on connecting the cable.If the mounting screws are too short, the camera may fall down. When installing the camera, thelength (C) that the screw extends past the other side of the camera base should be 3 cm ormore.(A)(A)(A) (B)(A) (C)(B)(A)112Adjusting the camera position and angleUse the accessory hexagon wrench (large) to loosen the screws of the part you would like to move,and then adjust so that the lens faces in the direction of monitoring within an angle of ±45 degrees.1 If the camera is adjusted to an angle of ±45 degreesor more, the cables will become twisted inside thecamera and they may break.2 Adjustment is possible within a range of 180 degrees.3 After adjusting the positions, tighten the screws to thefollowing torques.A: 2 N·m or more (8 places)B: 4.3 N·m or more (2 places)