– 17 –4. USB STORAGE INFORMATIONREGISTRATIONUSB storage data is important for when the camera is con-nected to a computer via a USB connection.If there are any errors in the USB storage data, or if it has notbeen saved, the USB specification conditions will not be sat-isfied, so always check and save the USB storage data.Preparation:POWER switch: ONAdjustment method:1. Connect the camera to a computer. (Refer to 3-5. Con-necting the camera to the computer on the page 13.)2. Double-click on the DscCalDi.exe.3. Click on the Get button in the USB storage window andcheck the USB storage data.VID: SANYOPID: S3Serial:Rev. : 1.004. Check the “Serial” in the above USB storage data. If thedisplayed value is different from the serial number printedon the base of the camera, enter the number on the baseof the camera. Then click the Set button.5. Next, check VID, PID and Rev. entries in the USB storagedata. If any of them are different from the values in 3. above,make the changes and then click the corresponding Setbutton.FirmwareImageAWBFocusUV MatrixR BrightRGB OffsetTintB BrightGainPhaseLCDCalibration UploadInitializeLCD Type H AFC TestVCOMDCVCOMPPCal DataCal ModeOKOKEVFUSB storageGetSetVID SetPID SetSerial SetRev. SetSettingLanguageVideo ModeVCOFactory CodeHall Cal.