Sanyo VPC S770 Instruction Manual

Preface iAbout this ManualEnglishPrefaceAbout this ManualThis manual is designed to assist you in using your new digital camera. Allinformation presented is as accurate as possible but is subject to change withoutnotice.CopyrightThis manual contains proprietary information protected by copyright. All rights arereserved. No part of this manual may be reproduced by any mechanical, electronicor other means, in any form, without prior written permission of the manufacturer.© Copyright 2007Federal Communications Commission (FCC) ComplianceThis equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged totry to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the distance between the equipment and the receiver.• Connect the equipment to an outlet on a circuit different from that to which thereceiver is connected.• Consult the dealer or an experienced radio/TV technician for help.Declaration of ConformityThis device complies with Part 15 of the FCC rules. Operation is subject to thefollowing conditions:• This device may not cause harmful interference.• This device must accept any interference received, including interference thatmay cause undersired operation.Warning: A shielded-type power cord is required in order to meet FCC emission limits and toprevent interference to radio and television reception. Use only shielded cable to connect I/Odevices to this equipment. Any changes or modifications not expressly approved by the man-ufacturer may void your warranty and service agreement.