Sanyo VPC-W800 User Manual

Contents

EN-17Charging the BatteryThe AC power adapter may charge the battery or operate the camera as power supply. Make surethat the power of the camera is off and then insert the battery before starting.1. Connect one end of the adapter to the DC IN 5V terminal onthe camera.2. Connect the other end of the AC power adapter into a walloutlet.J The status LED lights red when charging is started andlights off when charging is completed. The LED lightsgreen when a charging error has occurred or no battery isinserted inside the camera.J It is recommended to fully discharge the battery before recharging.J Charging time varies according to the ambient temperature and the status of battery.J This camera must be used with specified AC power adapter. Damage caused by the use of anincorrect adapter is not covered under the warranty.J Always make sure that the camera is off before removing the battery.J The battery may feel warm after it has been charged or immediately after being used. This isnormal and not a malfunction.J When using the camera in cold conditions, keep the camera and battery warm by storing it ina warm place such as an interior pocket between shots.J If you open the battery cover without removing the battery, the battery power will not bedisconnected.J If you remove the battery, you have to insert the battery within 2 hours in order to make surethat the date and time will not be reset.J When charging the battery, do not place the camera at the high temperature condition, suchas inside the quilt, under sunshine…etc.