EN-1FCC STATEMENT (For customers in USA)This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that may cause undesiredoperation.Note:This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCCrules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.Thisequipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. However, there is no guarantee that interference willnot occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one ormore of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules.Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If suchchanges or modifications should be made, you could be required to stop operation of the equipment.