21 EnglishCHARGING THE BATTERY PACKPlease charge the supplied battery pack before using it.1 Insert the battery pack in thebattery charger.h Insert it in the directionindicated by the [o] markon the battery pack.2 Connect the supplied powercord to the socket on thebattery pack charger.h Insert the connector straightand securely.3 Plug the power plug into apower outlet (AC 100 V to240 V).h Recharging begins.h During recharge, theCHARGE indicator is lit red.h The recharge time isapprox. 90 minutes.4 When the CHARGE indicatorturns off, unplug the powercord from the power outlet,and remove the battery packfrom the charger.HINTRecharging when connected to the USB terminal (page 9 in the SANYOSoftware Pack INSTRUCTION MANUAL)i The battery can be recharged while the camera is connected to a computer.i Note, however, that the time it takes to recharge will differ depending on the camera’soperating condition.i Connect the dedicated USB interface cable to the USB connector on your computer . Donot connect it to the USB connector on the monitor or the keyboard, or to the USB hub.i When the surrounding temperature is high, depending on the camera’s operatingcondition and the battery pack temperature, in some cases the multi-indicator mayslowly flash red and the battery pack cannot be charged.i If the camera is not going to be used for an extended period of time, please disconnectthe dedicated USB interface cable from the camera.Battery pack[o] markTo power outletCHARGE indicatorSocketPower cordCHARGE indicator
