22COMPUTER INPUTSELECTING INPUT SOURCEMENU OPERATIONDIRECT OPERATIONChoose Computer by pressing INPUT button on Top Control or onRemote Control Unit.If projector cannot reproduce proper image, select correct input sourcethrough MENU OPERATION (see below).Press MENU button and ON-SCREEN MENU will appear. PressPOINT LEFT/RIGHT button to move a red frame pointer toINPUT Menu icon.1INPUT buttonComputerVideoSELECTING COMPUTER SYSTEMThis projector automatically tunes to most different types of computers based on VGA, SVGA, XGA or SXGA (refer to“COMPATIBLE COMPUTER SPECIFICATIONS” on page 23). When selecting Computer, this projector automatically tunesto incoming signal and projects proper image without any special setting. (Some computers need setting manually.)Note : Projector may display one of the following messages.When projector cannot recognize connected signal as PCsystem provided in this projector, Auto PC Adjustmentfunction operates to adjust projector and the message“Auto” is displayed on SYSTEM Menu icon. (Refer toP24.) When image is not provided properly, manualadjustment is required. (Refer to P25 and 26.)There is no signal input from computer. Make sure theconnection of computer and a projector is set correctly.(Refer to TROUBLESHOOTING on page 41.)Auto––––SYSTEM Menu iconDisplays system beingselected.PC SYSTEM MENUSELECT COMPUTER SYSTEM MANUALLYSYSTEM Menu iconDisplays system being selected.The systems on this dialog boxcan be selected.Press MENU button and ON-SCREEN MENU will appear. PressPOINT LEFT/RIGHT buttons to move a red frame pointer to PCSYSTEM Menu icon.Press POINT DOWN button to move a red arrow pointer to thesystem that you want to set, and then press SELECT button.12PC SYSTEM MENUCustom Mode (1~5) set in PCADJUST Menu. (P25, 26)This projector automatically selects PC system among those providedin this projector and PC system can be also selected manually.Move a pointer (red arrow)to Computer and pressSELECT button.ComputerMove a pointer to RGB(Digital) or RGB (Analog)and press SELECT button.Source Select MenuINPUT MENUINPUT Menu iconPress POINT DOWN button to move a red arrow pointer toComputer and then press SELECT button. Source Select Menuwill appear.2Move a pointer to either RGB (Digital) or RGB (Analog) and thenpress SELECT button.3When digital signal is connected to DVI terminal,select Digital.RGB (Digital)When analog signal is connected to DVI terminal,select Analog.RGB (Analog)