Sapac F-16 Operation And Assembly Instructions

Contents

Sapac F-16 Operation And Assembly Instructions Manual pdf 7 page image

7Drill hole through the two ply wood washers to allow elevator rod to go in.Slide elevator in to fuselage.Glue plywood washer on to the elevator rod on the inside of the fuselage. This will prevent the elevatorcoming out in flight. Refer to photo above.Fit supplied linkage from servo to elevator. Refer to photo above.Note – You may use a small self tapper- screwed into the rod as well to secure ply disc and avoid possiblecontrol failureELEVONS ASSEMBERLY COMPLETEApply glue to fin and fin slot in fuselage. Refer to photo above.Slot fin in to fuselage and hold till dry.VERTICAL FIN COMPLETETIP: We recommend using Epoxy or CA glues as they are generally more reliable than a contact typeglue. If using contact glue supplied, apply to both surfaces then let dry till tacky then fit partstogether.NOTE: DO NOT USE TAPE TO HOLD JOIN WHEN REMOVED IT WILL REMOVE PAINT.Apply glue to tail cone and tail of fuselage fit andhold. Refer to photo.TAIL CONE COMPLETEINSTALL THE CANOPYGlue clear canopy to black base and hold till dry. Glue white hook to underside of canopy base, as perphoto. Glue black latch cone to underside of canopy base as per photo.