5.2- CONTROLLERSEvery 10 hours: check the safety and rigidity of the joints of the mechanism and tightness of the controller wires veryoften. (If necessary, tighten the bolts, nuts and other joining elements carefully) At the start of a working day check-Engine oil level,-Fuel level in the tank.Check the oil level in the gearbox of the tractor and the hoe and make the necessary addition.Main parts1)Gas lever2)Engine stop lever3)Handle bar adjuster4)Engine starter lever5)Air filter6)Hoe protection cover7)Blades8)Spur unit9)Clutch lever5.3- MOTORUN ÇALIÞTIRILMASI VE DURDURULMASIMotor tanýtma ve kullanma kýlavuzuna bakýnýz. Motoru çalýþtýrmadan önce daima þunlarý kontrol edin.- Yakýt deposu dolumu?- Diþli kutusundaki yað doðru seviyesinde mi? ( Þekil-3 )Motor stop kolu ile kavrama kolu bir yay sayesinde beraberce bloke edilir. ( Þekil-4 ) Aksi taktirde motor çalýþmaz.Motoru çalýþtýrmak için kontrol kolunu (start) çalýþtýrma konumuna getirin. Çalýþtýrma ipini “ E “ tutamaðýndan tekelle kavrayýn. ( Þekil-6 ) Yavaþça diþli mandalý tutana kadar çekin ve sonra hýzla çekin. Motor bir kez çalýþtýktansonra tutamaðý hemen býrakmayýn. Ýp tamamen sarýlýncaya kadar gevþekçe tutun. Sonra gaz kolunu “ C “ kursunortasýna getirin. ( Þekil-5 )5.3- STARTING AND STOPPING THE ENGINERead the engine manual. Before starting the engine first check these:-Is the fuel tank full?-Is the oil level in the gearbox at the correct position (Figure-3)Press safety device and clutch lever and lock them with hinge (Figure-4). Otherwise the engine does not start. Tostart the engine, adjust the control lever to the working (start) position. Hold the operation rope at the “E” holder withone hand (Figure-6). Pull slowly until the gear grips the lever and then pull it fast. Once the engine is run, do notrelease the handle. Hold it loosely until the rope is completely wound. Then put the gas lever “C” in the middle(Figure-5).(8)Þekil: 5(Fig:5)Þekil: 4(Fig:4) Þekil: 6(Fig:6)Þekil: 3(Fig:3)