TBK vision BUL7436EIR User Manual

TBK vision BUL7436EIR User Manual Manual pdf 26 page image

21TBK Vision Plus Network Camera User Manual1. Select the sensor.2. The following setup steps are similar to Motion Detection Schedule’s. Please refer toMotion Detection Schedule chapter for more details.4.4.6 Alarm Out1. Go to “Alarm configuration” “Alarm output” as shown below:2. Select alarm holding time and alarm name at the “Alarm out” and “Alarm holding time”pull down list box respectively.3. Press the “Save” button to save the settings.4.4.7 Alarm ServerGo to “Alarm configuration”“Alarm Server” interface as shown below.You may input the alarm server address and port. When the alarm happens, the camera willautomatically transfer the alarm event to the alarm server. If the alarm server is not used, thereis no need for you to configure here.4.5 Network ConfigurationNetwork configuration includes nine submenus: Port, IP Address, Server Configuration, IPNotify, DDNS Config, RTSP, UPNP, Mail configuration and FTP.4.5.1 Port1. Go to“Network config”“Port” to see the interface as shown below.