TC-Helicon VOICELIVE Touch Quick Start Manual

Also see for VOICELIVE Touch: User manual

Contents

TC-Helicon VOICELIVE Touch Quick Start Manual Manual pdf 4 page image

4Mounting to a Mic StandMIC STAND SETUP1. With no cables attached to the product, grasp it on both sides sothe printed top faces you and is approximately level.2. Slide VoiceLive Touch to the left so that the upper shaft of yourmic stand is captured by the lower slot on the product. (Figure 1)3. Slowly but firmly lower the front of the product so the serratedslot fully captures the micstand shaft. (Figure 2) You’ll feel initialresistance then the shaft should snap in and seat tightly.Removal is the reverse: lift the front of the product so it snaps free ofthe micstand shaft then slide right to remove.Note that micstand diameter should not exceed 16.5 mm.CABLINGThe horizontal mounting slot on VoiceLive Touch is also used to collectyour cables. As shown in the graphic below, cables can be threadedthrough the slot. Use the provided cable wrap to tie your cables neatlyto your micstand.