TCL 48FS4690 User Manual

Also see for 32S3600: User guide

TCL 48FS4690 User Manual Manual pdf 12 page image

11ANT/CABLE/SAT IN Outdoor or indoor AntennaCable Box,( Wall Outlet)RF Coa xialWire(75 ohm )OrOrConnections and SetupObtain the SignalThe first step in connecting your TV is obtaining the signal. The back panel of your TV allows you to receiveanalog and/or digital channels by using the HDMI or ANT/CABLE/SAT connections. To obtain the bestquality, use the HDMI connection.Connect the outside ariel to the ANT/CABLE/SAT INconnection on the back of the TV to receive off-air channels.Use an HDMI connection to display the best picture andsound quality for satellite and cable• If you have a set-top box, you may need to call yourcable company or satellite service provider. They mayrecommend special cables to allow you to view digitalchannels.• The aerial socket (75 OHM - VHF / UHF / cable) can beused for connecting an external aerial or other equipmentfitted with a modulator (video recorder, satellite receiver,etc.). We recommend that you do not connect otherequipment (video recorder, satellite receiver, etc.) toyour TV set to begin with, so as not to complicate theset-up procedure with the additional steps involved. Connect them when you have finished setting up thechannels.• Visit www.antennaweb.org for help in deciding what type of antenna to use in order to receive the localdigital channels available to you. Enter your location, and the program will list local analog and digitalstations available using your antenna.Switching OnFollow the instructions on this page on how to switch on your TV set and use the remote control before goingon to following pages describing how to use the channel scan procedure.1. Insert two AAA batteries in the remote control.Precautions on using batteries:- Only use the battery types specified.- Make sure you use the correct polarity.- Do not mix new and used batteries.- Do not use rechargeable batteries.- Do not expose batteries to excessive heat such as sunshine, fire or the like, throw them in a fire,recharge them or try to open them, as this could cause them to leak or explode.- Remove the batteries from the remote control if you are not using it for a long period of time.2. Connect the power cable to a power outlet. (If the power cable is not connected to the television, pleasefirst connect the power cable to the television.) Your TV set should only be connected to an AC supply.It must not be connected to a DC supply. If the plug is detached from the cable, do not, under anycircumstances, connect it to a power outlet, as there is a risk of electric shock.3. When powered on, if the TV set is in standby mode, press on the remote control or on the TV set toturn on the TV.Switching OffTo put the TV set into standby mode, press on the remote control or on the TV, the TV set remainspowered up, but with low energy consumption.To disconnect power from the TV set, unplug the power cord from the power outlet.