TCL LE32HDE5200 User Manual

Also see for LE32HDE5200: User guide

TCL LE32HDE5200 User Manual Manual pdf 11 page image

10Connections and SetupWireless Network Setup1. Select Connection > Settings > Configuration > Interface, press ◄/► to select Wierless to connect to a WiFiwireless network.2. Select Connection > Settings > Configuration > Wireless Setting, press OK/► to enter.3. Connection Methods: you can setup the wireless network connection three ways.- Scan• Select Wireless setting > Scan, then press OK/►, the TV will scan all available wireless networks withinrange. The networks found by the TV will be displayed.• Select an available access point, then press OK/► to connect the TV to it.Notes:- If you select a secure wireless network , you will have to enter the corresponding password to access it.- This TV will remember the password even if you switch on TV after power off.- ManualSelect Wireless setting > Manual, then press OK/►, you will be prompted to enter the correct SSID of anavailable wireless router to setup the connection.- AutoIf your wireless networks supports WPS (Wi-Fi Protected Setup), you can connect to the network via PIN(Personal Identification Number) or PBC (Push Button Configuration). WPS will automatically configurethe SSID and WPA key in either mode.Select Wireless setting > Auto, then press OK/►to enter.• PIN: select PIN, then press OK/► to enter. Generate a random PIN code and make sure this code is installedto the AP (for the procedures, refer to your router manual), then press OK/► again to setup the connection.• PBC: If your router has a PBC push button, select PBC, then press OK/► to enter. Press PBC push button onyour router within 2 minutes after you press OK/► again. Your TV will automatically acquire all the networksetting values it needs and connect to your network.InformationSelect Connection > Settings > Configuration > Information, press OK/► to display the information on currentconnection, such as Interface, Address type, IP address, etc..IP settingSelect Connection > Settings > Configuration > IP Setting, then press OK/► to enter the IP setting menu.- Set Address type to Auto, it will acquire and enter the needed IP address automatically.- You can follow below steps to enter your IP address manually if needed.• Set Address type to Manual, then press ▼ to go to the first entry field.• Enter the IP address, Subnet mask, Default gateway, Primary DNS and Secondary DNS values. Use thedigit buttons on your remote control to enter numbers and the arrow buttons to move from one entry field toanother.- After setting, select Connection > Configuration > Connection Test to check the Internet connectivity again.Connection TestSelect Connection > Settings > Configuration > Connection Test, then press OK/► to check the Internetconnectivity. If it doesn't work, follow above steps to ensure the connectivity or refer to your Internet Service Provider.