TCL S5209 Instructions Manual

Also see for 32S5203: Manual

EN8EnglishGetting startedImportant:Batteries shall not be exposed to excessive heat such as sunshine, fire or the like. Remove batteries whenthe remote control is not to be used for a long time. Batteries left in equipment may cause damage throughdeterioration and corrosive leakage, invalidating the guarantee.To protect the environment use local recycling facilities for battery disposal. Dispose of used batteriesaccording to the instructions.CAUTION: Risk of explosion if batteries are replaced by an incorrect type. Replace only with the same orequivalent type recommended by the equipment manufacturer.You can turn on the TV from standby mode by pressing the button on your TV set.While the TV is on, the multi-function menu appears by pressing the button on your TV set. For moreinformation about how to use the multi-function menu, please refer to the figure below.CH+ CH- Volume+ Source OKVolume-StandbyTips: Click to select options, press and hold to confirm.• Press the button to move the highlight to the next function selection.• Press and hold the button for more than 2 seconds to confirm your selection.Note: Please refer to the Quick Start Guide to find the button on your TV set.Switch the TV on and off1. When the power cord is connected, the TV will be turned on directly or be in standby mode. If the TV is instandby mode, press the or POWER/ button on the set or the button on the remote control to turn iton.2. To put the TV into standby mode, press the button on the remote control. The TV set remains powered up,but with low energy consumption.3. To switch the TV off, unplug the mains plug from the mains outlet.Initial setupThe first time you switch the set on, the Welcome screen appears, which guides you through the initial setupprocess. Follow the on-screen instructions to finish the initial setup process such as selecting the language,connecting to the network, scanning channels, and more. During each step, either make a choice or skip thestep. If you skip a step, you can perform the setup later from the settings menu.Note: If the channel search retrieved only the analogue channels it could be caused by poor broadcasting andtherefore is not covered by manufacturer warranty. Manufacturers cannot be held responsible for lack ofor poor broadcasting in some areas.