907/11/2016A Ground Breaking Company Since 1923Controller Configuration“More” takes the operator to “Controller Configuration”.“Drill” button takes the operator to the “Drill Settings” screen. This screen is only active inthe “Stopped” mode and should only be altered when the operator is changing from onemachine to another and in contact with either their Taege Dealer or Taege Engineering Ltdtechnical person.Some controllers require a "password" to access this screen.“Inputs” shows where the controller is configured to accept “High impedance”, “PNP” and“NPN” type sensors.

Introduction

Starting the Controller

Quick Calibration

Calibration Check

Operating the Controller

Additional Tasks

Controller Configuration

Glossary

Warning Screens

Taege RC350 Owner's Manual

RC350