TB9100 base stationP25 CG console gatewayCalibration SoftwareUser’s ManualMBA-00004-05Issue 5February 2007

Issue

Basic Tasks

About the Toolbar

Equipment Required

Field Calibration

P25 Console Gateway Calibration

Setting Up the Equipment

Connecting the Calibration Software

Adjusting the Frequency Setup

Tuning a UHF Receiver Front End

Tuning a VHF Receiver Front End

Adjusting the Exciter Lock Band

Selecting the Exciter Sub-band

Calibrating the Reciter

Calibrating the VCO

Calibrating the RSSI

Calibrating the Balanced Line

Calibrating the Unbalanced Lines

Calibrating the Power Amplifier

Calibrating the Forward and Reverse Detector Bias Voltages

Troubleshooting Tips

Calibrating the Power Management Unit

limited warranty

Tait TB9100 User Manual

installation and operation manual

contact information

Preface

Associated Documentation

Publication Record

Description

Features

Modules

Base Station Reciter

Power Amplifier

Front Panel

Frequency Bands and Sub-bands

V DC PA-Only Base Station/Repeater

Applications

Simulcast

Console Gateway

Signal Paths

Run and Standby Modes

Intermodule Communications

Power Management

Front Panel Fans

General Safety and Regulatory Information

AC Power Connection

Equipment Safety

Anti-tampering Devices

Regulatory Information

FCC Narrowbanding Regulations

Installation

Equipment Ventilation

Installing and Setting up the CSS

PC Recommendations

Setting Up on the Bench

Confirming Operation

Connecting the CSS for the First Time and Setting the IP Address

Finding a Lost or Forgotten IP Address

Customizing the Configuration

Changing the Root Password

Short Tuning Procedure

Checking the Modulation Fidelity

Other Operational Tests

Installing the Base Station on Site

Tait Limited March

Connecting Up the Base Station

Connecting AC Power

Connecting DC Power

Connecting the Auxiliary DC Power Output

Connecting RF

Connecting an External Frequency Reference

Connecting a 1PPS Source

Connecting an Antenna Relay

Connecting the Analog Line

Connecting General Purpose Inputs and Outputs

Operation

Speaker Operation

Monitoring with the CSS

Module LED Indicators and Switches

Maintenance

Troubleshooting

Replacing Modules

Preliminary Disassembly

Replacing the Control Panel

Configuring the Control Panel Board

Replacing a Reciter

Replacing a Power Amplifier

Replacing a Power Management Unit

Replacing the Front Panel Fans

Replacing the Module Guide Rails

Replacing the Subrack Interconnect Board

Configuring the Subrack Interconnect Board

Final Reassembly

Technical Description

Reciter Module Operation

PA Module Operation

PMU Module Operation

PMU Operation on DC Input

Control Panel

System Control Bus

Appendix A – Interface Pin Assignments

Microphone Connection

Appendix B – Inter-Module Connections

W Base Station

V PA Base Station

Dual Channel 5 or 50W Base Station

Five Reciters and One PMU

Seven Reciters

P25 Glossary

P25 CG

Receive-only Base Station

Line-Connected Base Station

Theory of Operation

Explosive Environments

ESD Precautions

Environmental Conditions

Unauthorized Modifications

Minimum PC Requirements for Running a CSS

Setting the IP Address

Tuning

Mounting the Subrack

Tait Electronics Limited January

Microphone Operation

TaitNet P25 Glossary

important notice

TB9100