Tait TM8100 Protocol Manual
Also see for TM8200 mobiles: Service manualInstallation guideInstallation guideAccessories manualOperator's manual
                                                                            | |
Contents
| 
TM8100/TM8200 Computer-Controlled Data Interface (CCDI) Protocol Manual CCDI 29© Tait Electronics Limited April 20071.9.4 GO_TO_CHANNELThe GO_TO_CHANNEL command tells the radio to change to anotherconventional mode channel. The specified channel can be assigned to ascan/vote group in the radio. A trunked radio must change to a conventionalchannel before executing this command.Format g [SIZE] [ZONE] [CHANNEL_NO] [CHECKSUM]■ ‘g’ is sent as a single ASCII character and represents theGO_TO_CHANNEL command.■ [ZONE] (optional for TM8200, not applicable for TM8100) is a two-character string representing the new zone. When [ZONE] is omitted,the radio stays in the current zone.■ [CHANNEL_NO] is a maximum of four characters representing thenew channel number. The range of allowed characters is 0 to 9. and mustbe a valid channel for the radio. If used with the [ZONE] parameter, thiswill always be a four-character string.Note If the radio is using a scan/vote group when it receives this com-mand, it will retune to the specified channel.Note If the radio is in emergency mode then no channel change willoccur, and a ‘not ready’ error message is returned.Examples g0223D2 go to channel 23.g0414995E go to channel 1499.g060100120F go to zone 1, channel 12. |
Related manuals for Tait TM8200 mobiles
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine