Tait TM9100 Installation Manual

Also see for TM9100: Installation guide Service manual User guide Installation guide Safety information

Tait TM9100 Installation Manual Manual pdf 24 page image

TM9100 Installation Guide Installing the Radio 25© Tait Electronics Limited August 20052.8 Installing the Radio1. Connect the antenna cable, power cable, and—if applicable—theauxiliary cable to the rear of the radio.2. Position the radio in the U-bracket so that the holes in the U-bracketline up with the holes in the radio chassis.3. Screw the radio into position using the four thumb screws provided,but without fully tightening the screws.4. Adjust the position of the radio in the U-bracket for the best viewingangle, then tighten the thumb screws.Figure 2.6 Installing the radio in the U-bracket