TallyGenicom 6300 Quick Start Manual

Also see for 6300 Series: Product guide Quick start guide Operator's manual Specifications Maintenance manual

Contents

TallyGenicom 6300 Quick Start Manual Manual pdf 1 page image

1. Remove the ShippingHardwareThere are 4 screws, identified by red tags, thatsecure the printer base to the inside mechanism,and tie restraints that secure the Paper StackingChains. The upper 2 shipping screws have wing-heads which tighten a bracket against the platen toprevent it from bumpingagainst the hammer bank.The lower 2 shippingscrews fasten fromunderneath, near thefront of the printercabinet. Remove all ofthese restraints, includingthe brackets beneath thewing-head screws.LG SeriesQuick Start GuidePaper comes out between these twosets of chains.Rear Paper Guide2. Set Up Paper Stacking ChainsPaper exits the print area through a set of passive Paper Stacking Chainsthat help fold and stack printed forms uniformly. Secure two of thechains to the wire guide and two to the rear paper guide so that thepaper can be fed between them. Make sure chains are not tangled.Serial Interface PortParallel Interface PortOn/Off Switch& Power Plug3. Connect the I/O and Power UpSecure the cable to the printer interface using the correct connectors.Shielded I/O cables must be used on all installationsto comply with regulatory requirements.4. Install the Ribbon CartridgeStep A. Open the printer lid. Remove slack in the new ribbon by turning the knob on the ribbon cartridge as indicated by the arrow printednext to the knob.TractorsRibbon CartridgeShaft forTractorsStep B. Carefully position the ribbon between the two panels of the ribbon shield.Step C. Press down lightly on the cartridge while turning the ribbon knob as before until it seats onfirst the left, (as shown), and then the right cartridge drive posts. Make sure that the ribbon doesnot twist or fold over.Optional LANinterface orOptional Twinax/Coax interfaceHammerBankHousingRibbon Cartridge