Talon Tools AKA104 User Manual
Contents |
AU5• INSTALLING THE ATTACHMENTNOTE: To make installing or removing the attachmenteasier, place the unit on the ground or on a work bench.1. Turn the knob (A) counterclockwise to loosen (Fig.1A).2. While firmly holding the attachment (B), push itstraight into the Quick-Change coupler (C) until therelease button (D) appears in the primary hole (E) ofthe Quick-Change coupler. (Fig. 1B)3. Turn the knob (A) clockwise to tighten. (Fig. 1C)All attachments are designed to be used in the primaryhole unless otherwise indicated in the specific attach-ments operators manual. If the incorrect hole is used, itcould result in injury, or damage to the unit.1. Move the cultivator to the work area prior to startingthe engine/motor.2. Start the unit.3. With the engine running and the tines off the ground,depress the throttle control to increase the enginespeed.4. Holding both of the shaft and handle grips firmly,slowly lower the cultivator until the tines make contactwith the ground. (See Fig. 2)5. As cultivating action begins, pull back on the cultivatorso that the tines can penetrate the ground.6. Once the ground has been broken, continue at a mod-erate pace until you are familiar with the controls andthe handing of the cultivator.• TINE REMOVAL AND REPLACEMENTAll 4 tines should be replaced at the same time becausethey will wear evenly through normal use. Work on oneside at a time.1. Unplug the power cord before cleaning or performingmaintenance or removing or installing tine.2. Remove the clevis pin clips (A) and clevis pins (B).(See Fig. 3A)3. Remove the tines (C) and felt cushions (D) from theshaft (E). (See Fig. 3B)4. Clean and oil the shaft.5. The tines are stamped with the letter “R” or “L” to iden-tified their position on each side of the gearbox whenfacing the front of the unit.6. Replace the tines (C) and felt cushions (D) onto theshaft with the hubs on the tines facing each other.7. Ensure the tips on tines are allgned in the same direc-tion with each other before reinstalling the clevis pinsand pin clips.8. Repeat this procedure on the opposite side.NOTE:When installed correctly, there will be an “R” and “L”tine on each side of the gearbox and the tips on the tinesline up in the same direction. It is important that the tinesare installed correctly.ASSEMBLY INSTRUCTIONSWARNING: To avoid serious personal injury,shut unit off before removing or installingattachment.CAUTION: The release button must be in theprimary hole and the knob securely tightenedbefore operating this unit.Fig. 1A Fig. 1BABDC DEDAFig. 1COPERATING INSTRUCTIONSWARNING: Dress properly to reduce the riskof injury when operating this unit. Do notwear loose clothing or jewellery. Wear eyeand ear/hearing protection. Wear heavy, longpants, boots and gloves. Do not wear shortpants, sandals or go barefoot.Fig. 2A Fig. 2BMAINTENANCE INSTRUCTIONSWARNING: To prevent serious personal injury,always wear heavy gloves when handling thetines. |
Related manuals for Talon Tools AKA104
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine